items: 0total: £0.00 currency
EuroPound SterlingUS Dollar
cart
Application Instructions

Getting Started: You will need masking or painters tape, squeegee (OR CREDIT CARD), scissors, friend (recommended). CLEAN AND DRY THE SURFACE where you will be applying your WALLART. Make sure it is smooth, dry and free of debris.

1 Clean and dry your wall. Unroll your WALLART  (leaving both coatings on) and lay it out on a clean flat surface with the  WALLART facing upward. 

2 Leaving both coatings on, pre-hang the WALLART in the desired location with masking or painters tape. Adjust as needed. Use the tape again to mark the surface at corners and areas around the perimeter of the WALLART. Remove the WALLART leaving the corner and perimeter tape markings behind.

3 Flip the WALLART face down (paper side up). Your goal is to release the WALLART from the white paper backing. It is best to begin with an end that has the least amount of detail. Crease or fold back the paper backing and slowly and firmly press down while pulling back the paper at surface level. Constantly preview the WALLART to ensure it is releasing from the paper. If necessary, use your fingernail to release stubborn areas and smooth them to the clear coat. Cut away excess paper as you work your way down (optional).

4 After the paper backing is completely removed, position your WALLART within your tape markings. Firmly squeegee the WALLART to the surface working outward. SLOWLY peel off the PAPER transfer coating, leaving the WALLART behind.
5 Your done stand back and appreciate your work, and don't forget to tell your friends


MUST KNOW BASICS

Inspect your installation surface and correct any unsightly blemishes. WALLART decals are made of a thin, flexible vinyl that will take on the texture of your wall or surface Major imperfections may puncture the vinyl during installation.

The recommended wall texture for successful decal application and adhesion is SMOOTH properly primed, painted and cured drywall that has little or no surface variation. Glass, smooth metal, plastic, laminate, porcelain and other non-porous substrates are also acceptable.

Newly painted surfaces should dry for at least 2 weeks prior to installation. If paint is not completely dry, Decals may not adhere properly, or may lift paint off the wall when you decide to remove it.
WALLART decals will NOT adhere to textured surfaces such as rough drywall, stucco, plaster or faux finishes. They will NOT adhere to oil-based paints, wet surfaces or fibrous materials such as fabric or canvas. Direct sunlight or moisture may loosen the adhesive over time and compromise the product.

DISCLAIMER WALLART is not responsible for misapplication, substrate adhering issues or damages caused during installation. If you are not comfortable with installation, we recommend hiring a professional painter or wallpaper hanger that is familiar with wall decals.